RFID Reader Module
Fully-integrated, low-cost method of reading passive RFID transponder tags: 2400 baud TTL serial interface (output only) to PC, BASIC Stamp module and other processors. Requires single +5VDC supply, Bi-color LED for visual indication of activity. Requires RFID tags (part # 5-129)Data Sheet
RFID Reader Module, Milford Part # 5-128 @ £32.50 each
50mm RFID Tags, Part # 5-129 at £2.50 each
RS232 Serial-Bluetooth adapter
The EmbeddedBlue Transceiver AppMod provides standard Bluetooth connectivity for BASIC Stamp® module applications without the need for detailed Bluetooth knowledge. Check here for app manual.ManualMilford Part # 1-400 @ £79.00 each
(Parallax part # 30068)
Hitachi HM755B Compass Module
This Compass Module made exclusively by Parallax is a dual-axis magnetic field sensor built around the Hitachi HM55B IC.- Sensitive to microtesla (µT) variations in magnetic field strength.
- Simplifies direction by resolving magnetic field measurements into two components axes.
- 6-bit (64-direction) resolution after calibration.
- Only 30 to 40 ms between start measurement and data-ready with simple synchronous serial interface.
- Built-in resistor protection for data pins eliminates bus conflict risks.
- Compact and breadboard-friendly 0.3 inch, 6-pin DIP package.
- Compatible with all BASIC Stamp, Javelin Stamp, and SX microcontrollers.
Milford Part # 5-127
(Parallax part #29123 )
Price £25.00 each
Memsic 2125 Dual-axis Accelerometer
The Memsic 2125 is a low cost, dual-axis thermal accelerometer capable of measuring dynamic acceleration (vibration) and static acceleration (gravity) with a range of ±2 g.- Measure 0 to ±2 g on either axis; less than 1 mg resolution
- Fully temperature compensated over 0° to 70° C range
- Simple, pulse output of g-force for X and Y axis
- Analog output of temperature (TOut pin)
- Low current operation: less than 4 mA at 5 vdc
Milford Part # 1-124
(Parallax part # 28017 )
Price £25.00 each
Temerature/Humidity Sensor
The SHT1x is factory calibrated so that it returns temperature with a resolution of 0.01 degrees Celsius and relative humidity with a resolution of 0.03 percent. The accuracy is better than most other sensors too. Worst-case temperature accuracy is +/- 2 degrees C - but in the "room temperature" range the accuracy better than +/- 1 degree C. The relative humidity sensor is similarly accurate: +/- 3.5% in the range 20% to 80%.Data sheet
Milford Part # 1-125
(Parallax part # 28018 )
Price £25.00 each
Flexiforce Sensor Demo Kit
The active sensing area is a .375" diameter circle at the end of the sensor. The conductive leads are easy to connect to a breadboard or through-hole area. The Flexiforce has an ideal output for A/D conversion - 0V is no force and 4.2V is 100 lbs.
Milford Part # 1-126
(Parallax part # 30056)
Price £17.50 each
TCS230 Color Sensor Evaluation Kit
The TCS230 sensor module set is comprised of a complete color detector, including a TAOS TCS230 RGB sensor chip, white LEDs, collimator lens, AppMod adapter board, and connecting cable. It interfaces easily to any BASIC Stamp® module, either through an AppMod socket or connected directly, and can detect and measure a nearly limitless range of visible colors. Applications include color edge-following robots, sorting by color, and color matching, to name just a few. Data sheet
Milford Part # 1-127
(Parallax part # 30054
Price £75.00 each
USB Adapter
No serial port? Then you will need this USB to Serial (RS232) adapeter to programme your BASIC Stamp® module. Works well when used with any BASIC Stamp® module or Javelin Board Application.
Milford Part # 1-430
(Parallax part # 28030 )
Price £12.50 each
MMC-BS2
- Carrier board for the Motor-mind C plus a Parallax Basic Stamp2
Active cooling kit for the above: Order part # 5-214 at £17.50
Milford Part # 5-213
Price £20.00 each
Easy Roller Wheel Assembly
Nice geared motor and wheel kit with mounting bracket and hardware kit.
Milford Part # 5-215
Price £15.00 each
Mini PID Position Controller
Use with a DC brush servo motor and quadrature encoder to form a highlyversatile, low-cost position control module for servo motors up to 40V and 2A continuous. Windows programming and set-up/test software.
Data sheet
Milford Part # 5-210
Price £25.00 each
MemKey
- Simple serial interface (1 or 2 wire interface)
- Supports up to 4x5 key keypad
- Generates ascii or PC/AT codes
- Typematic functions
- Key debounce
- Eeprom stored setup data
- Size 55x35mm
Milford Part # 1-921
(Parallax Part # 27963)
Price £35.00 each
Keyboard processor
- Interface PS/2 keyboard to BASIC Stamp® module (2-pin RS232 connection)
- Outputs standard ascii characters
- Mouse interface option (X/Y position)
- Includes chip/resonator and documentation
Milford Part # 1-805
Price £27.50 each
Connector Packs
Handy pluggable jumper wires that connect to standard 0.1" header strips.
- 12 wires per pack
- 150mm long
Milford Part # 1-937
Price £10.00 each